2002 Hyundai Accent Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

2002 Hyundai Accent

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 2002 Hyundai Accent


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Enter Programming Mode – Step 1

    REMOVE dashboard fascia and LOCATE the alarm system control module. ENSURE that the memory switch is in the OFF position.

    Santa Fe / XG300 / XG350: Access alarm system control module located behind driver’s side fascia panel (Fig 100573)

    Elantra / Sonata: Access central locking signal control module located behind fascia, center (Fig 100645)

  2. Enter Programming Mode – Step 2

    INSERT key into the ignition and TURN ignition to the ON position.

    NOTE: Some have reported that leaving the key out of the ignition works for their vehicle. If this procedure does not work for you, try skipping this step.

  3. Enter Programming Mode – Step 3

    After 5 seconds SLIDE the switch on the alarm system control module to the SET position.

  4. Program Remote

    PRESS the LOCK button on the first remote to be programmed.

  5. Program Additional Remote

    If programming a second remote PRESS the LOCK button on the second remote.

  6. Exit Programming Mode

    SLIDE the switch on the alarm system control module to the OFF position. TURN the ignition OFF and REMOVE key and REPLACE center fascia to EXIT Programming Mode.

  7. Test Remotes

    TEST all remotes. Programming is now complete.

  8. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.
  • Keyless Entry Control Module Location:
    • Santa Fe / XG300 / XG350: Access alarm system control module located behind driver’s side fascia panel (Fig 100573)
    • Elantra / Sonata: Access central locking signal control module located behind fascia, center (Fig 100645)
  • Important: Please check to ensure you are able to find the Alarm Control Module and associated SET Switch mentioned in the instructions, otherwise you will not be able to perform the self-programming instructions and will be required to have an Automotive Locksmith program the key fob for you.
  • Alternative: If these instructions do not appear to work, try performing them again WITHOUT inserting the key into the ignition, as Steps 2 and 7 indicate, to see if this resolves the issue.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

2002 Hyundai Accent

OEM Electronic
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *