2000 Pontiac Grand Am Keyless Entry Remote Fob Programming Instructions

Pontiac Keyless Entry Remote Programming Instructions

Step-by-Step How To Programming Instructions for a 2000 Pontiac Grand Am Keyless Entry Remote Fob

We strive to provide convenience to our customers with free keyless entry remote programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Step-by-Step How To Programming & Memory Clearing Instructions for a 2000 Pontiac Grand Am Keyless Entry Remote Fob

Verify that this important information is on the back of your remote before using these programming instructions.

FCC ID: KOBUT1BT

Factory Part No: 25678792, 25628814, 25668603

Programming Notes:

Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.

Keyless Entry System Memory Clearing Instructions are noted in the dark blue colored steps below.

Step-by-Step How To Programming Instructions:

  1. Close driver’s side door.
  2. Insert key into ignition and turn ignition to ON then back to OFF (ON is the position just shy of starting car without cranking engine)
  3. Remove key from ignition.
  4. Press and hold the UNLOCK switch on drivers door and continue to hold until instructed to release.
  5. Insert key into the ignition (do not turn it) and remove it.
  6. Insert key into the ignition (do not turn it) and remove it.
  7. Insert key into the ignition (do not turn it) and leave it in.
  8. Release the UNLOCK switch on driver’s side door. Vehicle will respond with three acoustic sounds to indicate successful entry into programming mode.
  9. Press and hold the LOCK and UNLOCK buttons on the first remote to be programmed for 15-20 seconds until the vehicle beeps twice indicating successful programming.
  10. Repeat Step 9 for all remaining remotes to be programmed to the vehicle.
  11. Test all remotes. Programming is now complete.
  12. If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.
Save On Your Purchase by Sharing with Friends!
You about to save some mega moolah with NorthCoast Keyless! Save even more by sharing your purchase with friends and you will receive a special discount at checkout!


 

If you have any difficulties with programming the remote you ordered from us to your vehicle, check out our FAQ Page for common questions, mistakes, and solutions to programming keyless entry remotes to your vehicle. Always feel free to contact us at support@northcoastkeyless.com.

 

View our entire catalog of FREE Pontiac keyless entry remote programming instructions!

Need to buy a 2000 Pontiac Grand Am keyless entry remote fob? We’ve got you covered!

Need a new battery for your 2000 Pontiac Grand Am keyless entry remote fob? We’ve got that too!

Remote Accessories

CR2032 Lithium Coin Battery

Dealership: $8.00
$3.94

 

Our Free Programming Instructions Disclaimer can be found on the NorthCoast Keyless FAQ page.

Leave a Reply

Your email address will not be published.