2000 Chevrolet Venture Keyless Entry Remote Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

2000 Chevrolet Venture

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 2000 Chevrolet Venture


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Ensure Key is NOT in the Ignition

    REMOVE key from the Ignition.

  2. Remove Fuse

    REMOVE the MALL PGM / BCM PRGRM Fuse from the Fuse Box.

  3. Close All Doors

    CLOSE all doors and Rear Liftgate.

  4. Enter Programming Mode – Step 1

    INSERT key into Ignition and TURN to ACC (back toward you).

  5. Enter Programming Mode – Step 2

    WITHIN 1 second, TURN the Ignition to OFF then back to ACC (OFF is the position where you can remove your key).

  6. Enter Programming Mode – Step 3

    OPEN then CLOSE the Driver’s door. The Vehicle will sound indicating successful entry into Programming Mode.

  7. Program Remote

    PRESS and HOLD the LOCK and UNLOCK buttons on the remote for about 15 seconds until two chimes are heard.

  8. Program Additional Remotes

    REPEAT Step 7 for any additional remotes to be programmed, including working ones.

  9. Exit Programming Mode

    REMOVE key from Ignition and replace the MALL PGM / BCM PRGRM Fuse to EXIT Programming Mode.

  10. Test Remotes

    TEST all remotes. Programming is complete.

  11. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

2000 Chevrolet Venture

OEM - New/Used
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *