2000 Chevrolet Camaro Keyless Entry Remote Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

2000 Chevrolet Camaro

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 2000 Chevrolet Camaro


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Insert Key Into Ignition

    INSERT key into Ignition and TURN to RUN and then back to OFF (RUN is the position just shy of cranking the engine. OFF is where you can remove your key).

  2. Remove Radio Fuse

    REMOVE the Radio fuse from the Fuse Box. Fuse #17, located on the left-hand (LH) driver’s side of the instrument panel.

  3. Enter Programming Mode

    TURN Ignition from OFF to RUN 3 times within 5 seconds ending in the RUN position. Door locks will cycle LOCK / UNLOCK indicating successful entry into Programming Mode.

  4. Program Remote

    PRESS and HOLD the LOCK and UNLOCK buttons on the first remote to be programmed for 15 seconds until you hear the door locks cycle LOCK / UNLOCK to indicate successful programming of that remote.

  5. Program Additional Remotes

    REPEAT Step 4 for any additional remotes to be programmed, including working ones.

  6. Exit Programming Mode

    TURN Ignition OFF and REPLACE the Radio fuse to EXIT Programming Mode.

  7. Test Remotes

    TEST all remotes. Programming is complete.

  8. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

2000 Chevrolet Camaro

OEM Electronic
OEM Electronic
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *