1999 Chrysler Sebring Coupe Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1999 Chrysler Sebring Coupe

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1999 Chrysler Sebring Coupe


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Insert Key

    INSERT a key into the Ignition and LEAVE in the OFF position.

  2. Locate Data Link Connector

    LOCATE the Data Link Connector (DLC) under the Driver’s side dashboard. Use the diagram above to IDENTIFY Pins 1 and 4.
    Data Link Connector Port 1-16

  3. Enter Programming Mode – Step 1

    JUMP the Data Link Connector using a suitable ground wire (paperclip) from Pin 1 to Pin 4. DO NOT REMOVE the jumper wire until the end of the programming process.

  4. Enter Programming Mode – Step 2

    CLOSE all doors.

  5. Enter Programming Mode – Step 3

    TURN the Ignition to the ACC position and back to the OFF position. This MUST be done within 10 seconds of installing the jumper wire. If done properly, the vehicle Locks will cycle LOCK and UNLOCK automatically to signal successful entry into Programming Mode.

  6. Program Remote

    PRESS either the LOCK or UNLOCK buttons on the first remote to be programmed 3 times in 10 seconds. The vehicle Locks will again cycle LOCK and UNLOCK automatically to signal successful programming of the remote.

  7. Program Additional Remote

    REPEAT Step 6 to program any additional remotes to your vehicle.

  8. Exit Programming Mode

    REMOVE the jumper wire, TURN the Ignition to the OFF position and REMOVE the key from the Ignition to EXIT Programming Mode.

  9. Test Remotes

    TEST all remotes. Programming is complete.

  10. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1999 Chrysler Sebring Coupe

OEM - New/Used
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *