1998 Oldsmobile LSS Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1998 Oldsmobile LSS

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1998 Oldsmobile LSS


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Locate DLP

    LOCATE the OBDII Data Link Port (shown above) under the Driver’s side dash. Note that the port is wider on the top row and contains ports 1 through 8. Identify Ports 8 and 4, be sure there are metal pins inside those two ports.
    Data Link Connector Port 1-16

  2. Jump DLP

    JUMP Port 8 to Port 4 with a suitable ground wire (paperclip). LEAVE the jumper wire connected throughout the procedure.

  3. Close Doors

    CLOSE all doors.

  4. Enter Programming Mode

    INSERT key into the Ignition and turn it to the ON position. The vehicle will respond by locking the doors to indicate that the vehicle has entered Programming Mode.

  5. Program Remote

    PRESS and HOLD both the LOCK and UNLOCK buttons together on the first remote to be programmed. After about 15 seconds, the vehicle will respond by cycling the door locks LOCK / UNLOCK to signal successful programming of the remote. RELEASE the buttons on the remote.

  6. Program Additional Remotes

    WITHIN 1 minute, REPEAT Step 5 on all additional remotes, including working ones, to be programmed to the vehicle.

  7. Exit Programming Mode

    REMOVE the jumper wire connected to the Data Link Port to EXIT Programming Mode.

  8. Test Remotes

    TEST all remotes. Programming is complete.

  9. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1998 Oldsmobile LSS

USED
USED
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published.

{"cart_token":"","hash":"","cart_data":""}