1998 Jaguar XJ Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1998 Jaguar XJ

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1998 Jaguar XJ


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Enter Programming Mode – Step 1

    OPEN the Boot (Trunk) and LEAVE OPEN.

  2. Enter Programming Mode – Step 2

    OPEN Driver’s door and LEAVE OPEN.

  3. Enter Programming Mode – Step 3

    INSERT key into Ignition and TURN to the “ON” position (just shy of cranking engine).

  4. Enter Programming Mode – Step 4

    ROCK Valet Switch (located in center console) 5 times. The vehicle will CHIRP and FLASH headlamps to indicate successful entry into Programming Mode.

  5. Program Remote(s) – Step 1

    WITHIN 15 seconds, PRESS the ALARM/LOCK button on the first transmitter to be programmed. This transmitter will be programmed to Memory 1 position. Vehicle will TONE to signal successful programming of the transmitter.

  6. Program Remote(s) – Step 2

    ROCK Valet Switch 1 time. Vehicle will CHIRP 2 times to signal that it is ready to program a second transmitter.

  7. Program Additional Remote(s)

    REPEAT Steps 5-6 for each remote transmitter to be programmed (up to 5 total). Note: You MUST cycle thru 5 sets of Steps 5-6 in order to successfully complete the programming sequence. For example, if you only have 1 transmitter, program that transmitter and repeat Steps 5-6 until you’ve done it 5 times total.

  8. Exit Programming Mode

    TURN Ignition OFF, REMOVE key, CLOSE Boot and Driver’s door to EXIT Programming Mode.

  9. Test Remotes

    TEST all remotes. Programming is now complete.

  10. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.
  • You may program up to 5 total transmitters to your vehicle.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1998 Jaguar XJ

NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *