1997 Lexus SC 400 Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1997 Lexus SC 400

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1997 Lexus SC 400


TOYOTA AFTERMARKET/DEALER INSTALLED KEY FOB REMOTE STEP-BY-STEP HOW TO PROGRAMMING INSTRUCTIONS

Minutes 5 minutes

  1. Locate the ECU Programming Receiver

    LOCATE the ECU Programming Receiver.

  2. Enter Programming Mode – Step 1

    INSERT key into Ignition and TURN to the ON position.

  3. Enter Programming Mode

    PRESS and HOLD the ECU’s Programming Switch for 3 seconds using a paperclip or small screwdriver. The Status Monitor LED light will turn on for 5 seconds to indicate successful entry into Programming Mode..

  4. Program Remote(s)

    WITHIN 5 seconds, PRESS and RELEASE ANY button on the remote. The Status Monitor LED light will turn OFF, the piezo chirper will chirp ONCE and the exterior lights will flash ONCE to indicate successful programming of the remote. IF you hold the button too long and the vehicle alarm sounds, simply press the TOP button on the remote to reset the alarm.

  5. Exit Programming Mode

    TURN OFF the Ignition to EXIT Programming Mode.

  6. Test Remotes

    TEST all remotes. Programming is complete.

  7. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Supply:

  • Key Fob Remote(s) that you want to program to your vehicle.

Tools:

  • Paperclip

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.
  • Important: For MOST vehicles, the ECU Programming Receiver is located UNDERNEATH either the Driver or Passenger front seats. For SOME vehicles, it is located BEHIND the Driver’s Dash and can be accessed by prying out the black faceplate (5”x3”) BEHIND the mirror control switch. It is a BLACK box with 3 connectors and a recessed GREEN RESET button. Refer to the Owner’s Manual for your vehicle’s ECU location.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1997 Lexus SC 400

NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *