1996 Lincoln Continental Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1996 Lincoln Continental

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1996 Lincoln Continental


FORD LINCOLN MERCURY CROWN VICTORIA / MARK VIII KEY FOB REMOTES STEP-BY-STEP HOW TO PROGRAMMING INSTRUCTIONS

Minutes 5 minutes

  1. Enter Programming Mode – Step 1

    ENTER the 5-digit permanent entry code into the keyless entry keypad.

    This will be the permanent code given by the Dealership when the vehicle was new. It may be found in the original Owner’s Manual.

  2. Enter Programming Mode – Step 2

    PRESS the 1/2 button on the keyless entry keypad within 5 seconds.

    Doors will cycle Lock/Unlock to indicate successful entry into programming mode.

  3. Program Remote(s)

    PRESS any button on the remote to be programmed within 5 seconds of pressing the 1/2 button on the keyless entry keypad.

    Doors will cycle Lock/Unlock to indicate successful programming of the remote.

  4. Program Additional Remote(s)

    REPEAT the previous step within 5 seconds for any other remotes to be programmed to your vehicle.

  5. Exit Programming Mode

    PRESS the 7/8 and 9/0 buttons on the keyless entry keypad simultaneously to finalize programming and exit programming mode.

  6. Test Remote(s)

    TEST all remotes. Programming is now complete.

  7. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Supply:

  • Key Fob Remote(s) that you want to program to your vehicle.

Tools:

  • None

Important:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.

Note: If your vehicle cannot enter programming mode, then you cannot program any remote.  This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module.


If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1996 Lincoln Continental

OEM - New/Used
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *