1996 Isuzu Rodeo Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1996 Isuzu Rodeo

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1996 Isuzu Rodeo


HONDA / ACURA / ISUZU KEY FOB REMOTES STEP-BY-STEP HOW TO PROGRAMMING INSTRUCTIONS

Minutes 5 minutes

  1. Enter Programming Mode – Step 1

    LOCATE Keyless Entry System Receiver Module (refer to Instruction Notes or Owner’s Manual for location).

  2. Enter Programming Mode – Step 2

    TURN Ignition to ON (just shy of cranking the engine).

  3. Enter Programming Mode – Step 3

    LOCATE the Green Button on the side of the Keyless Entry Receiver Module. It will be recessed and accessible with an object such as a pen or paperclip.

  4. Enter Programming Mode – Step 4

    PRESS the Green Button until the vehicle’s exterior lights or the LED on the Driver’s side dashboard illuminate, then RELEASE the Green Button. The vehicle has successfully entered Programming Mode when the lights illuminate.

  5. Program Remote(s)

    WITHIN 5 seconds, PRESS and RELEASE the top button on the remote. The LED or exterior lights will turn OFF and the vehicle will “chirp” and flash the front lights to indicate successful programming of the remote.

  6. Program Additional Remote(s)

    REPEAT Steps 4 and 5 in order to program any additional remotes.

  7. EXIT Programming Mode

    TURN the ignition to OFF (I) and REMOVE the key to EXIT Programming Mode.

  8. Test Remotes

    TEST all remotes. Programming is now complete.

  9. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Supply:

  • Key Fob Remote(s) that you want to program to your vehicle.

Tools:

  • Paperclip
  • Pen

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.
  • IMPORTANT: The Keyless Entry System Receiver will EITHER be under the Driver’s seat OR behind the Dashboard. Check the Driver’s seat first. MOVE the Driver’s seat forward to access the Keyless Entry System Receiver located on the floor beneath the Driver’s seat. IF the Keyless Entry System Receiver is NOT beneath the Driver’s seat, REMOVE the Dashboard panel located to the left and below the steering wheel in order to access the Keyless Entry System Receiver module.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1996 Isuzu Rodeo

NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *