1994 Chrysler LHS Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1994 Chrysler LHS

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1994 Chrysler LHS


Time needed: 10 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Access Traction Control Connector – Step 1

    REMOVE the middle vent bezel from the center of the Dashboard.

  2. Access Traction Control Connector – Step 2

    LOCATE the 6 pin Traction Control Connector behind the vent. It will be black in color and should be connected to the vent bezel of the Traction Control Switch.

  3. Unplug Traction Control Connector

    UNPLUG the connector from the Traction Control Switch.

  4. Insert Key

    INSERT a key into the Ignition and TURN to the ON position (just before cranking).

  5. Enter Programming Mode

    JUMP the Traction Control Connector using a suitable ground wire (paperclip) from Pin 1 to Pin 4. DO NOT REMOVE the jumper wire until the end of the programming process. If the jumper wire is correctly installed, the door locks will LOCK and UNLOCK to indicate successful entry into Programming Mode.

  6. Program Remote

    PRESS ANY button on the first remote to be programmed. Locks will cycle again LOCK and UNLOCK to indicate successful programming of that remote.

  7. Program Additional Remote

    REPEAT Step 6 to program any additional remotes to your vehicle.

  8. Exit Programming Mode

    REMOVE the jumper wire, TURN the Ignition to the OFF position and REMOVE the key from the Ignition to EXIT Programming Mode.

  9. Test Remotes

    TEST all remotes. Programming is complete.

  10. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1994 Chrysler LHS

NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

One thought on “1994 Chrysler LHS Keyless Entry Remote Fob Programming Instructions

  1. Pingback: lhs remote access – App Logins

Leave a Reply

Your email address will not be published. Required fields are marked *