1994 Chevrolet Corvette Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

1994 Chevrolet Corvette

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 1994 Chevrolet Corvette


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Move Fobs Out of Range

    MOVE ALL key fob remotes out of range of the Vehicle (10-15 feet).

  2. Remove Fuse

    INSERT key into Ignition and TURN to ON (just shy of cranking).

  3. Enter Programming Mode – Step 1

    PUSH the TRIP/ODO button on the Driver Information Center (DIC) 2 times.

  4. Enter Programming Mode – Step 2

    WITHIN 5 seconds, PUSH and HOLD the FUEL INFO button on the DIC until the PKE light comes ON.

  5. Enter Programming Mode – Step 3

    TURN the Ignition to the OFF position and LEAVE the key in the Ignition. The PKE light will begin flashing to signal successful entry into Programming Mode.

  6. Program Remote

    MOVE one key fob remote into range. The PKE light will STOP flashing to signal successful programming of the remote.

  7. Move Fob Out of Range

    MOVE the key fob remote out of range again. The PKE light will START flashing again to signal that it is ready for the next key fob to be programmed.

  8. Program Additional Remotes

    To program any additional remotes, REPEAT Steps 6-7.

  9. Exit Programming Mode

    REMOVE the key from the Ignition in order to EXIT Programming Mode. It will take 2 minutes for the vehicle to EXIT Programming Mode.

  10. Test Remotes

    TEST all remotes. Programming is complete.

  11. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.
  • Turn Radio OFF during programming.

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

1994 Chevrolet Corvette

NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

1 thoughts on “1994 Chevrolet Corvette Keyless Entry Remote Fob Programming Instructions

Leave a Reply

Your email address will not be published. Required fields are marked *