2000 Mitsubishi 3000GT Keyless Entry Remote Fob Programming Instructions

Step-by-Step How To Programming Instructions for a 2000 Mitsubishi 3000GT Keyless Entry Remote Fob

We strive to provide convenience to our customers with free keyless entry remote programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Step-by-Step How To Programming & Memory Clearing Instructions for a 2000 Mitsubishi 3000GT Keyless Entry Remote Fob

Verify that this important information is on the back of your remote before using these programming instructions.

FCC ID: Coming Soon

Factory Part No.: Coming Soon

Programming Notes:

Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.

Data Link Connector Port 1-16

Keyless Entry System Memory Clearing Instructions are noted in the dark blue colored steps below.

Step-by-Step How To Programming Instructions:

  1. LOCATE the Data Link Connector (DLC) pictured above.  It will be located underneath the dashboard/steering column on the Driver’s side.  
  2. IDENTIFY DLC Ports 1 and 4 from the diagram above.  Notice the metal contacts inside both Ports 1 and 4.
  3. INSERT key into the Ignition and leave it in the OFF position.
  4. JUMP Ports 1 and 4 with a suitable jumper wire.  Any metal wire (paper clip) will do.  Ensure constant contact between both metal contacts and the jumper wire at all times throughout this procedure.
  5. Within ten (10) seconds, TURN the Ignition switch to ACC (back toward you)  then back to OFF (where you can remove the key).  The door locks will cycle once indicating successful entry into Programming Mode.
  6. PRESS the LOCK or UNLOCK button on the first remote to be programmed three (3) times within ten (10) seconds.  The door locks will cycle once indicating successful programming of that remote.
  7. REPEAT Step 6 for any additional remotes to be programmed within one (1) minute.
  8. REMOVE the jumper wire connected to the Data Link Port.
  9. Test all remotes. Programming is now complete.
  10. If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.
Save On Your Purchase by Sharing with Friends!
You about to save some mega moolah with NorthCoast Keyless! Save even more by sharing your purchase with friends and you will receive a special discount at checkout!

If you have any difficulties with programming the remote you ordered from us to your vehicle, check out our FAQ Page for common questions, mistakes, and solutions to programming keyless entry remotes to your vehicle. Always feel free to contact us at support@northcoastkeyless.com.

View our entire catalog of FREE Mitsubishi keyless entry remote programming instructions!

Need to buy a 2000 Mitsubishi 3000GT keyless entry remote fob? We’re working hard to get it in stock for you!

[Coming Soon]

Need a new battery for your 2000 Mitsubishi 3000GT keyless entry remote fob? Check out our lineup of keyless remote batteries!

Our Free Programming Instructions Disclaimer can be found on the NorthCoast Keyless FAQ page.

Leave a Reply

Your email address will not be published.